Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a little but it's still appealing. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will help whether the problem is persistent or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle or it gets wet while kayaking canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to large amounts of water.
You'll also need to make sure that the fob is completely dry prior to opening it and re-using it. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) It's another indication that it's been submerged.
A circuit that is wet can cause the battery's power to be depleted or even explode. If you can pull your keyfob 308 out of the water, turn the button side up and shake as much water out as possible before opening the casing. Once you have opened it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system may stop working include a dead coin battery, receiver module issues, signal interference, or a faulty electronic chip. If none of the above are the issue, you can reset the system by disconnecting 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from a distance and then warm up or cool down the car prior to entering. This feature is extremely helpful, especially during winter's cold and chilly months. However, there are times when the remote stop system stops functioning due to a variety of reasons, including the battery of a coin that is dead.
A coin-shaped battery in the key fob has a life span of two to four years, depending on how often it's utilized and where it was purchased. The date of use is written on the packaging or in the user manual.
If the key fob stopped functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it could have fried the chip. It is recommended to replace it.
If you're not certain the battery is defective You can test the voltage with an instrument set to the car's voltage range, and connect it to the minus and plus terminals. The voltage should range from 12-13 volts, but if it's lower, then the battery needs to be replaced. If you want to, you can try to reset your on-board computer by disconnecting the battery at 12 volts for a few minutes and reconnecting it in reverse order (positive cable first and then negative). The engine should then start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible that the receiver module has discovered a problem. It is the part that sends out a signal when your key fob is activated. It also acts as an alarm that stops the car from starting without the correct key.
This could be caused by various causes, such as water damage or just the aging process. If your Peugeot 308 key fob has been exposed dirty tap water, as in, the electronic chip inside is damaged. In this case it is necessary to take the unit apart and thoroughly clean it with isopropyl alcohol or electronic cleaner. When the battery is clean, you can try again.
If the issue is not resolved, it is recommended that you visit an area Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the issue and fix it.
Losing your Peugeot car keys can be an incredibly stressful experience. However, a trained auto locksmith can fix the problem in minutes. They can program your vehicle and cut a fresh, working key for you. Click here to locate locksmiths near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you may encounter issues starting your car or receive a message saying "anti-theft". In this instance the only option is to replace the key. Fortunately, peugeot boxer key with experience can provide the service within the shortest period of time.
The chip in your Peugeot 308's key fob may fail due to a variety of reasons, such as water damage, sweat or dirt. If your Peugeot key fob was exposed to dirty or soapy water, it must be cleaned right away. You can clean the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery should then be allowed to completely dry.
Radio interference can cause the key fob to cease working. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. If you experience this problem you should visit the Peugeot dealership.
The Peugeot key fob 207/308 is extremely delicate and requires special care. It is not recommended to drop it or throw it around. If you lose it, try to find it as quickly as possible. You can reset your on-board computer by disconnecting the battery for a few minutes. Unplug the negative cable prior to the positive.